power loss!

[hooliscooby27]

car reverted back to limp mode, was good for a week and a half after ecu reset
think it needs chip mapping, Scott T need to chat and get you to see if you can sort it out with pc lol
96 wagon import pipe, hks air filter induction all mods i know about
last dyno reading at 'spc' 154hp at crank fuel 12.5 : 1
running lean so im told
any help greatly recieved
Nick

[Scott.T]

We need to establish why it's doing it first, as i diubt a remap will solve it.
Has it logged any fault codes ?

[hooliscooby27]

well the check light doesnt come on. i need to connect just the 'green' connectors to check codes yeh?
ill see how it goes and then re check it
has anyone else had this type of problem

[Scott.T]

connect just the blacks then turn ignition on.

also check if the boost control solenoid is clicking, buy cracking open the throttle by hand (under the bonnet) and listening above the drivers suspension strut. The solenoid should ctart to clik when you open the throttle and then stop when you close it.

[hooliscooby27]

ok ill look at that too
ordered new hks replacement filter today checked old green one and its falling to pieces ;(
that cant help can it?